MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lub for ways and prevent rust

Thread Modes
Lub for ways and prevent rust
mfletch Offline
Sophmore
***
Posts: 79
Threads: 12
Joined: Dec 2013
Location: mansfield UK
#8
10-02-2016, 01:09 PM
Well I use EP90 oil only because I've go two gallons of it, use on ways and cutting but I only potter about on the lathe and mill don't use them every day
mfletch, Try to do the best you can and that's good enough
Reply
Thanks given by:


Messages In This Thread
Lub for ways and prevent rust - by Wongster - 10-01-2016, 11:29 PM
RE: Lub for ways and prevent rust - by Vinny - 10-02-2016, 04:57 AM
RE: Lub for ways and prevent rust - by Wongster - 10-02-2016, 05:02 AM
RE: Lub for ways and prevent rust - by Mayhem - 10-02-2016, 05:32 AM
RE: Lub for ways and prevent rust - by TomG - 10-02-2016, 08:19 AM
RE: Lub for ways and prevent rust - by f350ca - 10-02-2016, 09:55 AM
RE: Lub for ways and prevent rust - by mfletch - 10-02-2016, 01:09 PM
RE: Lub for ways and prevent rust - by Dr Stan - 10-02-2016, 10:06 PM
RE: Lub for ways and prevent rust - by Wongster - 10-02-2016, 11:10 PM
RE: Lub for ways and prevent rust - by Mayhem - 10-03-2016, 10:01 AM
RE: Lub for ways and prevent rust - by Wongster - 10-03-2016, 10:23 AM
RE: Lub for ways and prevent rust - by Dr Stan - 10-03-2016, 10:32 AM
RE: Lub for ways and prevent rust - by Wongster - 10-03-2016, 12:10 PM
RE: Lub for ways and prevent rust - by Mayhem - 10-04-2016, 07:16 AM
RE: Lub for ways and prevent rust - by Wongster - 10-04-2016, 07:37 AM
RE: Lub for ways and prevent rust - by Wongster - 10-05-2016, 01:36 AM
RE: Lub for ways and prevent rust - by Mayhem - 10-05-2016, 07:05 AM
RE: Lub for ways and prevent rust - by Wongster - 10-05-2016, 07:28 AM
RE: Lub for ways and prevent rust - by PixMan - 10-05-2016, 08:47 AM



Users browsing this thread: