|
Lathe Radius Attachment
|
10-13-2016, 03:22 PM
How do you adjust the ball diameter? If I'm looking at it correctly, your swing depends on which of the holes you have the center section sitting in. But that's only two sizes. Is that how it works?
Mike
SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Lathe Radius Attachment - by Hawkeye - 10-08-2016, 08:55 PM
RE: Lathe Radius Attachment - by Vinny - 10-08-2016, 09:41 PM
RE: Lathe Radius Attachment - by stevec - 10-09-2016, 07:07 AM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-09-2016, 11:46 AM
RE: Lathe Radius Attachment - by DaveH - 10-09-2016, 03:44 PM
RE: Lathe Radius Attachment - by krv3000 - 10-09-2016, 06:39 PM
RE: Lathe Radius Attachment - by Hawkeye - 10-09-2016, 09:15 PM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-12-2016, 05:25 PM
RE: Lathe Radius Attachment - by pepi - 10-13-2016, 06:07 AM
RE: Lathe Radius Attachment - by wawoodman - 10-13-2016, 03:22 PM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-13-2016, 03:57 PM
RE: Lathe Radius Attachment - by Hawkeye - 10-13-2016, 10:26 PM
|
