MetalworkingFun Forum › Machining › Projects v
Lathe Radius Attachment

Thread Modes
Lathe Radius Attachment
Hawkeye Offline
Junior
****
Posts: 531
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#12
10-13-2016, 10:26 PM
Al's on it again. In addition, I made a bar that has the ends cut back so that the front surface is at the centre of the first axis. You then use a scale or gauge block to set the radius. For the second axis, add 1" to the radius desired.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Lathe Radius Attachment - by Hawkeye - 10-08-2016, 08:55 PM
RE: Lathe Radius Attachment - by Vinny - 10-08-2016, 09:41 PM
RE: Lathe Radius Attachment - by stevec - 10-09-2016, 07:07 AM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-09-2016, 11:46 AM
RE: Lathe Radius Attachment - by DaveH - 10-09-2016, 03:44 PM
RE: Lathe Radius Attachment - by krv3000 - 10-09-2016, 06:39 PM
RE: Lathe Radius Attachment - by Hawkeye - 10-09-2016, 09:15 PM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-12-2016, 05:25 PM
RE: Lathe Radius Attachment - by pepi - 10-13-2016, 06:07 AM
RE: Lathe Radius Attachment - by wawoodman - 10-13-2016, 03:22 PM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-13-2016, 03:57 PM
RE: Lathe Radius Attachment - by Hawkeye - 10-13-2016, 10:26 PM



Users browsing this thread: 1 Guest(s)