MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Oops ... Now It's Too Small

Thread Modes
Help Oops ... Now It's Too Small
f350ca Offline
Senior
*****
Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario
#3
11-25-2016, 02:17 PM
I expect its cast iron, welding would warp it. Could you make the protrusion smaller and put set screws in the side of the chuck to centre it like a set through.
Ed probably has the best plan.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Oops ... Now It's Too Small - by arvidj - 11-25-2016, 11:47 AM
RE: Oops ... Now It's Too Small - by EdK - 11-25-2016, 02:04 PM
RE: Oops ... Now It's Too Small - by f350ca - 11-25-2016, 02:17 PM
RE: Oops ... Now It's Too Small - by Mayhem - 11-25-2016, 07:15 PM
RE: Oops ... Now It's Too Small - by pepi - 11-25-2016, 08:31 PM
RE: Oops ... Now It's Too Small - by ieezitin - 11-25-2016, 07:49 PM
RE: Oops ... Now It's Too Small - by EdK - 11-25-2016, 07:57 PM
RE: Oops ... Now It's Too Small - by Dr Stan - 11-25-2016, 08:22 PM
RE: Oops ... Now It's Too Small - by Hopefuldave - 11-25-2016, 08:35 PM
RE: Oops ... Now It's Too Small - by arvidj - 11-26-2016, 08:33 AM
RE: Oops ... Now It's Too Small - by arvidj - 11-30-2016, 04:11 PM



Users browsing this thread: 1 Guest(s)