MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Oops ... Now It's Too Small

Thread Modes
Help Oops ... Now It's Too Small
ieezitin Offline
Sophmore
***
Posts: 205
Threads: 27
Joined: Jan 2013
Location: Maryland USA
#5
11-25-2016, 07:49 PM
Leave it... its going to work to your advantage.. you may have slight runout on the new chuck you will be able to cancel it out ny playing with the draw bolts.

Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Oops ... Now It's Too Small - by arvidj - 11-25-2016, 11:47 AM
RE: Oops ... Now It's Too Small - by EdK - 11-25-2016, 02:04 PM
RE: Oops ... Now It's Too Small - by f350ca - 11-25-2016, 02:17 PM
RE: Oops ... Now It's Too Small - by Mayhem - 11-25-2016, 07:15 PM
RE: Oops ... Now It's Too Small - by pepi - 11-25-2016, 08:31 PM
RE: Oops ... Now It's Too Small - by ieezitin - 11-25-2016, 07:49 PM
RE: Oops ... Now It's Too Small - by EdK - 11-25-2016, 07:57 PM
RE: Oops ... Now It's Too Small - by Dr Stan - 11-25-2016, 08:22 PM
RE: Oops ... Now It's Too Small - by Hopefuldave - 11-25-2016, 08:35 PM
RE: Oops ... Now It's Too Small - by arvidj - 11-26-2016, 08:33 AM
RE: Oops ... Now It's Too Small - by arvidj - 11-30-2016, 04:11 PM



Users browsing this thread: 1 Guest(s)