MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Oops ... Now It's Too Small

Thread Modes
Help Oops ... Now It's Too Small
pepi Offline
Courious
****
Posts: 432
Threads: 27
Joined: Feb 2016
Location: Woodstock:GA
#8
11-25-2016, 08:31 PM
(11-25-2016, 07:15 PM)Mayhem Wrote: What Ed said.

Also, when getting close I would take a spring pass (i.e. don't advance the tool, just take another pass).

Good tip regarding close and spring pass, makes sense ..............thanks

greg
Magazines have issues, everything else has problems

Reply
Thanks given by:


Messages In This Thread
Oops ... Now It's Too Small - by arvidj - 11-25-2016, 11:47 AM
RE: Oops ... Now It's Too Small - by EdK - 11-25-2016, 02:04 PM
RE: Oops ... Now It's Too Small - by f350ca - 11-25-2016, 02:17 PM
RE: Oops ... Now It's Too Small - by Mayhem - 11-25-2016, 07:15 PM
RE: Oops ... Now It's Too Small - by pepi - 11-25-2016, 08:31 PM
RE: Oops ... Now It's Too Small - by ieezitin - 11-25-2016, 07:49 PM
RE: Oops ... Now It's Too Small - by EdK - 11-25-2016, 07:57 PM
RE: Oops ... Now It's Too Small - by Dr Stan - 11-25-2016, 08:22 PM
RE: Oops ... Now It's Too Small - by Hopefuldave - 11-25-2016, 08:35 PM
RE: Oops ... Now It's Too Small - by arvidj - 11-26-2016, 08:33 AM
RE: Oops ... Now It's Too Small - by arvidj - 11-30-2016, 04:11 PM



Users browsing this thread: 1 Guest(s)