|
Mach 3 Question
|
11-27-2016, 08:42 AM
Glad you found what was wrong but I find it strange that G-code made it thru the driver without any issues but manual commands did not. By the time it makes it to the driver it should have been source agnostic. But maybe the software architecture is not what I would envision it to be.
Oh well, at least it is working. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Mach 3 Question - by Hawkeye - 11-25-2016, 09:26 PM
RE: Mach 3 Question - by arvidj - 11-26-2016, 09:09 AM
RE: Mach 3 Question - by Hawkeye - 11-26-2016, 11:52 PM
RE: Mach 3 Question - by arvidj - 11-27-2016, 08:42 AM
RE: Mach 3 Question - by Hawkeye - 11-28-2016, 12:40 AM
RE: Mach 3 Question - by Mayhem - 11-28-2016, 06:50 AM
RE: Mach 3 Question - by Roadracer_Al - 12-02-2016, 11:11 AM
RE: Mach 3 Question - by Hawkeye - 12-02-2016, 11:23 PM
|
