MetalworkingFun Forum › Machinery › Lathes v
Gear lever not engaging

Thread Modes
Gear lever not engaging
f350ca Offline
Senior
*****
Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario
#7
12-01-2016, 06:21 PM
It says to shift under 600 rpm, my Summit is the same, almost impossible to shift stopped and you don't roll it over by hand in the low gears.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Gear lever not engaging - by aRM - 11-30-2016, 04:20 PM
RE: GEAR LEVER NOT ENGAGING - by f350ca - 11-30-2016, 05:30 PM
RE: GEAR LEVER NOT ENGAGING - by aRM - 12-01-2016, 10:32 PM
RE: GEAR LEVER NOT ENGAGING - by Vinny - 11-30-2016, 06:19 PM
RE: GEAR LEVER NOT ENGAGING - by aRM - 12-01-2016, 10:36 PM
RE: GEAR LEVER NOT ENGAGING - by Dr Stan - 11-30-2016, 08:48 PM
RE: GEAR LEVER NOT ENGAGING - by aRM - 12-01-2016, 10:40 PM
RE: GEAR LEVER NOT ENGAGING - by Mayhem - 12-01-2016, 08:22 AM
RE: GEAR LEVER NOT ENGAGING - by Dr Stan - 12-01-2016, 10:38 AM
RE: GEAR LEVER NOT ENGAGING - by aRM - 12-01-2016, 10:42 PM
RE: GEAR LEVER NOT ENGAGING - by f350ca - 12-01-2016, 06:21 PM
RE: GEAR LEVER NOT ENGAGING - by Dr Stan - 12-01-2016, 07:26 PM
RE: Gear lever not engaging - by Roadracer_Al - 12-01-2016, 10:04 PM
RE: Gear lever not engaging - by aRM - 12-01-2016, 10:46 PM
RE: Gear lever not engaging - by Dr Stan - 12-01-2016, 10:33 PM
RE: Gear lever not engaging - by aRM - 12-01-2016, 11:02 PM
RE: Gear lever not engaging - by Pete O - 12-02-2016, 03:27 AM
RE: Gear lever not engaging - by aRM - 12-02-2016, 07:05 AM
RE: Gear lever not engaging - by Dr Stan - 12-02-2016, 12:38 PM
RE: Gear lever not engaging - by aRM - 12-02-2016, 01:20 PM
RE: Gear lever not engaging - by aRM - 12-04-2016, 11:21 AM
RE: Gear lever not engaging - by aRM - 12-02-2016, 07:52 AM
RE: Gear lever not engaging - by Pete O - 12-04-2016, 09:10 PM
RE: Gear lever not engaging - by krv3000 - 12-05-2016, 03:43 PM



Users browsing this thread: 2 Guest(s)