ER Collet Chuck Pt. 3
#14
nice thanks for posting how you did it, now where did I hide that hunk of truck axle at, I need a couple of those for my lathes. your description of how you did the taper is the easiest that I have seen posted on any of the forums that I visit.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
ER Collet Chuck Pt. 3 - by DaveH - 04-22-2012, 11:47 AM
RE: ER Collet Chuck Pt 3 - by DaveH - 04-22-2012, 12:23 PM
RE: ER Collet Chuck Pt 3 - by DaveH - 04-22-2012, 12:26 PM
RE: ER Collet Chuck Pt. 3 - by doubleboost - 04-22-2012, 03:24 PM
RE: ER Collet Chuck Pt. 3 - by EdK - 04-22-2012, 03:49 PM
RE: ER Collet Chuck Pt. 3 - by Wongster - 04-23-2012, 03:19 AM
RE: ER Collet Chuck Pt. 3 - by aametalmaster - 04-22-2012, 07:18 PM
RE: ER Collet Chuck Pt. 3 - by krv3000 - 04-23-2012, 02:09 AM
RE: ER Collet Chuck Pt. 3 - by Mayhem - 04-23-2012, 05:51 AM
RE: ER Collet Chuck Pt. 3 - by Wongster - 04-23-2012, 09:04 AM
RE: ER Collet Chuck Pt. 3 - by Wongster - 04-23-2012, 09:10 AM
RE: ER Collet Chuck Pt. 3 - by DaveH - 04-25-2012, 10:47 PM
RE: ER Collet Chuck Pt. 3 - by Wongster - 04-25-2012, 11:26 PM
RE: ER Collet Chuck Pt. 3 - by dallen - 04-26-2012, 07:40 AM
RE: ER Collet Chuck Pt. 3 - by DaveH - 04-26-2012, 08:41 AM



Users browsing this thread: 3 Guest(s)