MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
What size QCTP for a 9x20 lathe

Thread Modes
What size QCTP for a 9x20 lathe
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#6
04-26-2012, 08:08 PM
He will buy the wedge. I have the wedge type which I bought based upon PixMan's recommendation at the time. I had also read countless posts on various sites that supported the choice. So, in the end, it was a no brainer.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
What size QCTP for a 9x20 lathe - by Mayhem - 04-25-2012, 02:56 AM
RE: What size QCTP for a 9x20 lathe - by EdK - 04-25-2012, 05:49 AM
RE: What size QCTP for a 9x20 lathe - by EdK - 04-25-2012, 03:53 PM
RE: What size QCTP for a 9x20 lathe - by PixMan - 04-26-2012, 07:40 PM
RE: What size QCTP for a 9x20 lathe - by Mayhem - 04-26-2012, 08:08 PM
RE: What size QCTP for a 9x20 lathe - by Bill Gruby - 06-22-2012, 07:07 AM
RE: What size QCTP for a 9x20 lathe - by Mayhem - 09-30-2014, 09:34 AM
RE: What size QCTP for a 9x20 lathe - by krv3000 - 11-26-2014, 07:00 PM



Users browsing this thread: 1 Guest(s)