Idea --- Surface Grinder
#11
Bill,
I would be very interested in the build, looking forward to seeing it.

Greg
Magazines have issues, everything else has problems

Reply
Thanks given by:
#12
(01-30-2017, 08:36 PM)EdK Wrote:
(01-30-2017, 08:07 PM)rleete Wrote: Care to post a pic or two?

Of what? I haven't built one yet.

Ed

I'm guessing a pic or two of the CAD drawings
Hunting American dentists since 2015.
Reply
Thanks given by:
#13
Yes, mayhem has it right. Just curious about the design.

Then again, why haven't you got it done yet?
Full of ideas, but slow to produce parts
Reply
Thanks given by:
#14
It's way down on the list.
It's 55 sheets so I'll create a PDF file and post it here this evening if I get time.

Ed
Reply
Thanks given by: Bill Gruby
#15
That would be great Ed. Even though it is smaller some might find it easier help to follow along with the prints. Ours is similar in design but some parts are totally different.

"Billy G"
Reply
Thanks given by:
#16
Our Spindle. The motor is coupled to it with a Lovejoy coupling shown at the left.


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#17
(01-31-2017, 11:45 AM)EdK Wrote: It's way down on the list.
It's 55 sheets so I'll create a PDF file and post it here this evening if I get time.

Ed

You'll just have to work faster.  Slacker.
Full of ideas, but slow to produce parts
Reply
Thanks given by:
#18
Our wheel arbor. The circle shows the movable weight slot.


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#19
I recommend taking a hard look at the material & hardware one would need to purchase, especially the bearings as run of the mill bearings will not cut it.
Reply
Thanks given by: Bill Gruby
#20
I used to work for NDH General Motors Bearing Division. We have what we need. Very good observation though. Run of the mill stuff won't work here. 5200 series double row in front with 5200 series single row rear.

"Billy G"
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)