First real project on the mill
#2
Dan,

Fantastic job on the install. I also have an Enco RF-45 clone mill, an older one than yours, and tried mounting a 'Z' DRO to it but ended up having to take it off because it was binding. The quill has some slop in it so it can twist when lowered. I'm not sure how to deal with that problem yet.

Ed
Reply
Thanks given by:


Messages In This Thread
First real project on the mill - by DanH - 04-25-2012, 02:22 PM
RE: First real project on the mill - by EdK - 04-25-2012, 03:43 PM
RE: First real project on the mill - by krv3000 - 04-25-2012, 05:13 PM
RE: First real project on the mill - by DanH - 04-25-2012, 05:21 PM
RE: First real project on the mill - by EdK - 04-25-2012, 06:39 PM
RE: First real project on the mill - by DaveH - 04-25-2012, 08:49 PM
RE: First real project on the mill - by DanH - 04-27-2012, 12:43 PM
RE: First real project on the mill - by RobWilson - 04-26-2012, 12:29 PM
RE: First real project on the mill - by ETC57 - 04-26-2012, 01:17 PM
RE: First real project on the mill - by DanH - 04-27-2012, 12:41 PM
RE: First real project on the mill - by Dave J - 05-09-2012, 11:16 AM



Users browsing this thread: 1 Guest(s)