Wondering about a t&c grinder
#12
(02-28-2017, 12:37 PM)Vinny Wrote:
(02-28-2017, 12:39 AM)Dr Stan Wrote: I ended up going with a surface grinder and an end mill sharpening attachment.

Thanks DOC!  Last thing I needed to do was spend more money.  Just found one on ebay, new, from Travers for $67.  Supposed to be here later in the week.

So when will you buy a tool post grinder such as a 1hp Dumore?   Smiley-dancenana
Reply
Thanks given by:


Messages In This Thread
Wondering about a t&c grinder - by Pete O - 02-27-2017, 07:26 AM
RE: Wondering about a t&c grinder - by TomG - 02-27-2017, 05:46 PM
RE: Wondering about a t&c grinder - by Hawkeye - 02-27-2017, 11:47 PM
RE: Wondering about a t&c grinder - by Pete O - 02-28-2017, 12:25 AM
RE: Wondering about a t&c grinder - by Dr Stan - 02-28-2017, 12:39 AM
RE: Wondering about a t&c grinder - by Vinny - 02-28-2017, 12:37 PM
RE: Wondering about a t&c grinder - by Dr Stan - 02-28-2017, 01:52 PM
RE: Wondering about a t&c grinder - by Dr Stan - 03-08-2017, 12:12 AM
RE: Wondering about a t&c grinder - by Mayhem - 02-28-2017, 05:13 AM
RE: Wondering about a t&c grinder - by Pete O - 03-06-2017, 10:19 PM
RE: Wondering about a t&c grinder - by Dr Stan - 03-07-2017, 12:31 PM
RE: Wondering about a t&c grinder - by Pete O - 03-07-2017, 04:22 PM
RE: Wondering about a t&c grinder - by Vinny - 03-08-2017, 04:07 PM



Users browsing this thread: 1 Guest(s)