|
NPT Internal Threads
|
One thing many/most forget is the 60 degree cutting tool should be aligned with the taper, not the axis of the lathe.
BTW, the only thing that crosses/interchanges between Imperial & Metric threads are the taper pipe threads. Learned this on a trip to Germany. Thanks given by: Wongster
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
NPT Internal Threads - by Wongster - 04-28-2017, 07:44 PM
RE: NPT Internal Threads - by TomG - 04-28-2017, 08:15 PM
RE: NPT Internal Threads - by Wongster - 04-28-2017, 09:11 PM
RE: NPT Internal Threads - by Vinny - 04-28-2017, 09:22 PM
RE: NPT Internal Threads - by Wongster - 04-28-2017, 10:11 PM
RE: NPT Internal Threads - by Vinny - 04-28-2017, 10:27 PM
RE: NPT Internal Threads - by Wongster - 04-28-2017, 10:48 PM
RE: NPT Internal Threads - by Vinny - 04-28-2017, 11:06 PM
RE: NPT Internal Threads - by Vinny - 04-28-2017, 11:34 PM
RE: NPT Internal Threads - by Wongster - 04-29-2017, 12:32 AM
RE: NPT Internal Threads - by Vinny - 04-29-2017, 10:36 AM
RE: NPT Internal Threads - by Wongster - 04-30-2017, 04:11 AM
RE: NPT Internal Threads - by Vinny - 04-30-2017, 10:38 AM
RE: NPT Internal Threads - by Dr Stan - 04-30-2017, 07:26 PM
RE: NPT Internal Threads - by Wongster - 05-05-2017, 03:45 AM
RE: NPT Internal Threads - by Mayhem - 05-05-2017, 05:48 AM
RE: NPT Internal Threads - by stevec - 05-05-2017, 06:17 AM
RE: NPT Internal Threads - by Mayhem - 05-05-2017, 08:18 AM
RE: NPT Internal Threads - by Vinny - 05-05-2017, 10:30 AM
RE: NPT Internal Threads - by Wongster - 05-05-2017, 11:00 AM
RE: NPT Internal Threads - by Vinny - 05-05-2017, 11:30 AM
RE: NPT Internal Threads - by Wongster - 05-05-2017, 11:40 AM
RE: NPT Internal Threads - by Wongster - 05-06-2017, 02:04 AM
RE: NPT Internal Threads - by Vinny - 05-06-2017, 10:07 AM
RE: NPT Internal Threads - by Wongster - 05-06-2017, 11:20 AM
RE: NPT Internal Threads - by Mayhem - 05-06-2017, 09:24 PM
|
