MetalworkingFun Forum › Machining › General Metalworking Discussion v
Protecting knee mill table top

Thread Modes
Protecting knee mill table top
Viperspit Offline
Freshman
**
Posts: 21
Threads: 9
Joined: Apr 2017
Location: Michigan
#3
04-29-2017, 04:50 PM
(04-29-2017, 04:34 PM)Vinny Wrote: I didn't check out this video but in your hard turning video I noticed the covers and liked the idea.

Hi Vinny,

We did another video on surface grinding thin parts flat using paper towels. We hope to have that one posted tomorrow.

Steve
Reply
Thanks given by:


Messages In This Thread
Protecting knee mill table top - by Viperspit - 04-29-2017, 01:39 PM
RE: Protecting knee mill table top - by Vinny - 04-29-2017, 04:34 PM
RE: Protecting knee mill table top - by Viperspit - 04-29-2017, 04:50 PM
RE: Protecting knee mill table top - by EdK - 04-29-2017, 04:52 PM
RE: Protecting knee mill table top - by Viperspit - 04-29-2017, 06:44 PM
RE: Protecting knee mill table top - by EdK - 04-29-2017, 11:28 PM
RE: Protecting knee mill table top - by Mike E. - 04-29-2017, 06:41 PM
RE: Protecting knee mill table top - by Hawkeye - 04-29-2017, 10:48 PM
RE: Protecting knee mill table top - by Mike E. - 05-09-2017, 11:55 AM
RE: Protecting knee mill table top - by Viperspit - 05-09-2017, 03:17 PM
RE: Protecting knee mill table top - by Mike E. - 05-09-2017, 06:12 PM
RE: Protecting knee mill table top - by Viperspit - 05-09-2017, 06:21 PM



Users browsing this thread: 1 Guest(s)