MetalworkingFun Forum › Machining › General Metalworking Discussion v
Protecting knee mill table top

Thread Modes
Protecting knee mill table top
Hawkeye Offline
Junior
****
Posts: 532
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#7
04-29-2017, 10:48 PM
I have three treadmill belts lying around doing nothing. They should do a pretty good job and may be hard enough to resist chips melting very far into the surface.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Protecting knee mill table top - by Viperspit - 04-29-2017, 01:39 PM
RE: Protecting knee mill table top - by Vinny - 04-29-2017, 04:34 PM
RE: Protecting knee mill table top - by Viperspit - 04-29-2017, 04:50 PM
RE: Protecting knee mill table top - by EdK - 04-29-2017, 04:52 PM
RE: Protecting knee mill table top - by Viperspit - 04-29-2017, 06:44 PM
RE: Protecting knee mill table top - by EdK - 04-29-2017, 11:28 PM
RE: Protecting knee mill table top - by Mike E. - 04-29-2017, 06:41 PM
RE: Protecting knee mill table top - by Hawkeye - 04-29-2017, 10:48 PM
RE: Protecting knee mill table top - by Mike E. - 05-09-2017, 11:55 AM
RE: Protecting knee mill table top - by Viperspit - 05-09-2017, 03:17 PM
RE: Protecting knee mill table top - by Mike E. - 05-09-2017, 06:12 PM
RE: Protecting knee mill table top - by Viperspit - 05-09-2017, 06:21 PM



Users browsing this thread: 1 Guest(s)