|
Protecting knee mill table top
|
05-04-2017, 02:38 PM
I made a set of plywood covers with a single piece of solid wood in the middle to index it to a table slot. The ends are cut to fit snugly around the vise. In a fit of optimism, I sprayed them with 2~3 coats of shellac. They got filthy instantly, anyway.
IIRC, I got the idea from Tom Lipton. They handle hot chips just fine. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Protecting knee mill table top - by Viperspit - 04-29-2017, 01:39 PM
RE: Protecting knee mill table top - by Vinny - 04-29-2017, 04:34 PM
RE: Protecting knee mill table top - by Viperspit - 04-29-2017, 04:50 PM
RE: Protecting knee mill table top - by EdK - 04-29-2017, 04:52 PM
RE: Protecting knee mill table top - by Viperspit - 04-29-2017, 06:44 PM
RE: Protecting knee mill table top - by EdK - 04-29-2017, 11:28 PM
RE: Protecting knee mill table top - by Mike E. - 04-29-2017, 06:41 PM
RE: Protecting knee mill table top - by Hawkeye - 04-29-2017, 10:48 PM
RE: Protecting knee mill table top - by Roadracer_Al - 05-04-2017, 02:38 PM
RE: Protecting knee mill table top - by Mike E. - 05-09-2017, 11:55 AM
RE: Protecting knee mill table top - by Viperspit - 05-09-2017, 03:17 PM
RE: Protecting knee mill table top - by Mike E. - 05-09-2017, 06:12 PM
RE: Protecting knee mill table top - by Viperspit - 05-09-2017, 06:21 PM
|
