Counter shaft / lay shaft
#4
Has anyone any advise on the speeds I should be aiming for at the chuck?
I'm going to start out using a 1450 rpm motor possibily running a 2 1/2" or 3" pulley on to an 8" pulley on the layshaft. The cone pulley on both layshaft & lathe spindle are 3 1/2", 4 1/2" & 5 1/2".
The lathe also has a back gear but I don't know the reduction on that yet, will have to count gear teeth.
Reply
Thanks given by:


Messages In This Thread
Counter shaft / lay shaft - by Andy T - 05-24-2017, 11:39 AM
RE: Counter shaft / lay shaft - by Pumpjack - 05-24-2017, 02:49 PM
RE: Counter shaft / lay shaft - by dallen - 05-24-2017, 03:20 PM
RE: Counter shaft / lay shaft - by Andy T - 05-25-2017, 08:55 AM
RE: Counter shaft / lay shaft - by Mayhem - 05-25-2017, 09:01 AM
RE: Counter shaft / lay shaft - by Andy T - 05-25-2017, 10:12 AM
RE: Counter shaft / lay shaft - by Mayhem - 05-26-2017, 06:04 AM
RE: Counter shaft / lay shaft - by Andy T - 05-27-2017, 09:30 AM
RE: Counter shaft / lay shaft - by Mayhem - 05-27-2017, 09:58 AM
RE: Counter shaft / lay shaft - by Andy T - 05-27-2017, 01:54 PM



Users browsing this thread: 2 Guest(s)