|
Who knows Cincinatti Toolmaster mills?
|
07-16-2017, 11:57 PM
Pete, I'm assuming you found the same thread I did: http://www.practicalmachinist.com/vb/cin...1b-262404/
If I'm understanding that correctly the oddball bit can likely be removed to reveal a #40 taper? |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Who knows Cincinatti Toolmaster mills? - by Pete O - 07-16-2017, 07:37 AM
RE: Who knows Cincinatti Toolmaster mills? - by TomG - 07-16-2017, 07:51 AM
RE: Who knows Cincinatti Toolmaster mills? - by Dr Stan - 07-16-2017, 02:03 PM
RE: Who knows Cincinatti Toolmaster mills? - by Pete O - 07-16-2017, 10:48 PM
RE: Who knows Cincinatti Toolmaster mills? - by Pete O - 07-16-2017, 11:32 PM
RE: Who knows Cincinatti Toolmaster mills? - by SteveG - 07-16-2017, 11:57 PM
RE: Who knows Cincinatti Toolmaster mills? - by Pete O - 07-17-2017, 12:30 AM
RE: Who knows Cincinatti Toolmaster mills? - by SteveG - 07-17-2017, 12:46 AM
RE: Who knows Cincinatti Toolmaster mills? - by Mayhem - 07-17-2017, 04:50 AM
|
