The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




Threading
#1
This may be something that everyone already does but just in case ...

When cutting threads in a lathe, rather than using a thread micrometer I sometimes just check the fit with a nut from the hardware store.  A couple of them are stored in the same place as the taps/dies of the same thread dimension/classification/pitch.

This is normally adequate for class 2A threads (most common type) when you feel just slight movement between the nut and the threaded part.  If a rare requirement for 3A threads, with tighter tolerances, arises, the thread dimensions should be checked with the thread mike.

   

P.S.  I HATE measuring (or trying to measure) thread pitch using thread wires.  You need four hands most of the time, despite all of the weird suggestions (modeling clay, masking tape, styrofoam, etc) from experts.

   
Reply
Thanks given by:


Messages In This Thread
Threading - by randyc - 08-13-2017, 08:42 PM
RE: Threading - by the penguin - 08-13-2017, 09:14 PM
RE: Threading - by randyc - 08-13-2017, 09:59 PM
RE: Threading - by TomG - 08-14-2017, 04:45 PM
RE: Threading - by randyc - 08-14-2017, 06:46 PM
RE: Threading - by f350ca - 08-14-2017, 07:47 PM
RE: Threading - by TomG - 08-14-2017, 10:21 PM



Users browsing this thread: 1 Guest(s)