No Transfer Punches ?
#12
(08-31-2017, 07:46 AM)Mayhem Wrote: ......I took three set screws and turned a 60° point on them and then milled two flats either side of the point, so I could screw them into place with some long nose pliers.  Screw all three in, turn the chuck over and give it a tap.  Three holes perfectly located.

6799
That is a danged ingenious idea !  If I don't remember it next time I need threaded transfer punches, I should hang up my calipers.

How about making them out of grade 8 fasteners ?
Reply
Thanks given by:


Messages In This Thread
No Transfer Punches ? - by randyc - 08-25-2017, 05:37 PM
RE: No Transfer Punches ? - by f350ca - 08-25-2017, 07:13 PM
RE: No Transfer Punches ? - by randyc - 08-25-2017, 08:58 PM
RE: No Transfer Punches ? - by TomG - 08-26-2017, 02:37 PM
RE: No Transfer Punches ? - by wawoodman - 08-30-2017, 01:30 PM
RE: No Transfer Punches ? - by Highpower - 08-30-2017, 01:59 PM
RE: No Transfer Punches ? - by Alphonse - 08-30-2017, 02:46 PM
RE: No Transfer Punches ? - by kwoodhands - 02-09-2018, 06:10 PM
RE: No Transfer Punches ? - by Vinny - 08-30-2017, 08:22 PM
RE: No Transfer Punches ? - by randyc - 08-30-2017, 09:23 PM
RE: No Transfer Punches ? - by Vinny - 08-30-2017, 09:26 PM
RE: No Transfer Punches ? - by Mayhem - 08-31-2017, 07:46 AM
RE: No Transfer Punches ? - by randyc - 08-31-2017, 04:54 PM
RE: No Transfer Punches ? - by Brian - 04-24-2018, 01:03 AM



Users browsing this thread: 1 Guest(s)