Fixing a Leaky RF-45 Mill Head - Grizzly G0519

[henryarnold]

Reinstall the quill yoke and depth limit hardware and then the front panel. Reinstall the depth pointer.
   
I reinstalled my down feed DRO which attaches to the front panel and has a plunger which connects to the quill yoke. Install the speed selector handles.
   
All done! I played with my "new" mill for about an hour. It runs a quieter and sounds smoother. The paint on the head is much better than before so the mill looks better.

Best of all, the next morning there was no puddle of oil on my table.