SteveG's Van Norman #12 mill
#5
This video might be helpful. It was done by a member here, don't recall seeing anything from him lately tho. It's about setting up the compound for that angle.

https://www.youtube.com/watch?v=YCllVu4K738
Logan 200, Clarke 7x12, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, ...
Reply
Thanks given by:


Messages In This Thread
SteveG's Van Norman #12 mill - by SteveG - 09-06-2017, 08:57 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-06-2017, 09:23 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-15-2017, 02:11 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-15-2017, 04:54 AM
RE: SteveG's Van Norman #12 mill - by Vinny - 09-15-2017, 07:01 PM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-15-2017, 10:51 PM
RE: SteveG's Van Norman #12 mill - by Pete O - 09-16-2017, 04:56 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-16-2017, 08:06 AM
RE: SteveG's Van Norman #12 mill - by Dr Stan - 09-16-2017, 09:48 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-18-2017, 08:20 AM
RE: SteveG's Van Norman #12 mill - by f350ca - 09-18-2017, 11:42 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-18-2017, 09:52 PM



Users browsing this thread: 1 Guest(s)