SteveG's Van Norman #12 mill
#11
Great to see chips Steve.
The method you used to mount the mandrel, using the collet itself should work but for some reason doesn't. I did the same thing resurfacing the mount for a collet chuck. I turned a heavy piece down to give a 1 inch spigot, then grabbed that with the collet chuck. You would think this should remove all runout, but when I ground the taper for the lathe spindle mount I still had 1 thou runout. No idea where it crept in.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
SteveG's Van Norman #12 mill - by SteveG - 09-06-2017, 08:57 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-06-2017, 09:23 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-15-2017, 02:11 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-15-2017, 04:54 AM
RE: SteveG's Van Norman #12 mill - by Vinny - 09-15-2017, 07:01 PM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-15-2017, 10:51 PM
RE: SteveG's Van Norman #12 mill - by Pete O - 09-16-2017, 04:56 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-16-2017, 08:06 AM
RE: SteveG's Van Norman #12 mill - by Dr Stan - 09-16-2017, 09:48 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-18-2017, 08:20 AM
RE: SteveG's Van Norman #12 mill - by f350ca - 09-18-2017, 11:42 AM
RE: SteveG's Van Norman #12 mill - by SteveG - 09-18-2017, 09:52 PM



Users browsing this thread: 1 Guest(s)