Milling sub plate.Gett
#10
You need a tapping head and a spiral point tap!
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
Reply
Thanks given by:


Messages In This Thread
Milling sub plate.Gett - by contraptioneer - 09-25-2017, 09:18 PM
RE: Milling sub plate.Gett - by Dr Stan - 09-25-2017, 09:27 PM
RE: Milling sub plate.Gett - by Highpower - 09-26-2017, 04:20 AM
RE: Milling sub plate.Gett - by TomG - 09-26-2017, 09:01 AM
RE: Milling sub plate.Gett - by contraptioneer - 09-26-2017, 08:59 PM
RE: Milling sub plate.Gett - by f350ca - 09-26-2017, 09:22 PM
RE: Milling sub plate.Gett - by contraptioneer - 09-27-2017, 12:00 PM
RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 08:29 PM
RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 08:33 PM
RE: Milling sub plate.Gett - by Vinny - 09-28-2017, 09:35 PM
RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 10:32 PM
RE: Milling sub plate.Gett - by Vinny - 09-29-2017, 05:59 AM
RE: Milling sub plate.Gett - by contraptioneer - 09-29-2017, 01:08 PM
RE: Milling sub plate.Gett - by contraptioneer - 09-29-2017, 01:17 PM
RE: Milling sub plate.Gett - by the penguin - 09-30-2017, 10:02 AM
RE: Milling sub plate.Gett - by contraptioneer - 09-30-2017, 11:50 AM
RE: Milling sub plate.Gett - by contraptioneer - 10-04-2017, 10:15 PM
RE: Milling sub plate.Gett - by Highpower - 10-04-2017, 11:11 PM
RE: Milling sub plate.Gett - by contraptioneer - 10-07-2017, 09:32 PM
RE: Milling sub plate.Gett - by contraptioneer - 10-07-2017, 09:40 PM



Users browsing this thread: 1 Guest(s)