Question about my mill.

Thread Modes

Question about my mill.

Hawkeye Offline

Junior

Posts: 532
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada

09-30-2017, 10:31 PM

While this one is not exactly the same, it does have some similarities, including the belt drive.

https://www.youtube.com/watch?v=zf0MVdoh5-Q

Take a look around this site: http://www.lathes.co.uk/taylormiller/ He tends to have information you can't find elsewhere. If you do find specifics on your mill, you can sent it to him and he'll post an article on yours.

Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Question about my mill. - by contraptioneer - 09-28-2017, 08:43 PM

RE: Question about my mill. - by Roadracer_Al - 09-29-2017, 04:19 AM

RE: Question about my mill. - by TomG - 09-29-2017, 08:16 AM

RE: Question about my mill. - by contraptioneer - 09-29-2017, 04:39 PM

RE: Question about my mill. - by contraptioneer - 09-29-2017, 04:41 PM

RE: Question about my mill. - by TomG - 09-29-2017, 10:14 PM

RE: Question about my mill. - by contraptioneer - 09-30-2017, 12:32 PM

RE: Question about my mill. - by Hawkeye - 09-30-2017, 10:31 PM