MetalworkingFun Forum › Machining › General Metalworking Discussion v
I need some help with this repair

Thread Modes
I need some help with this repair
f350ca Offline
Senior
*****
Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario
#8
10-10-2017, 08:29 AM
Is the cylinder steel or part of the tractor housing? If its steel I'd go cast iron for the piston, steel on steel is likely to gall unless one is really hard, not a sissy steel.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
I need some help with this repair - by Pete O - 10-09-2017, 05:28 AM
RE: I need some help with this repair - by TomG - 10-09-2017, 09:07 AM
RE: I need some help with this repair - by f350ca - 10-09-2017, 12:19 PM
RE: I need some help with this repair - by SteveG - 10-09-2017, 08:30 PM
RE: I need some help with this repair - by Pete O - 10-09-2017, 09:41 PM
RE: I need some help with this repair - by TomG - 10-10-2017, 07:01 AM
RE: I need some help with this repair - by f350ca - 10-10-2017, 08:29 AM
RE: I need some help with this repair - by Pete O - 10-10-2017, 04:45 PM
RE: I need some help with this repair - by Pete O - 10-11-2017, 04:38 AM
RE: I need some help with this repair - by Pete O - 10-14-2017, 05:25 AM
RE: I need some help with this repair - by TomG - 10-14-2017, 07:38 AM
RE: I need some help with this repair - by f350ca - 10-14-2017, 09:08 AM
RE: I need some help with this repair - by Pete O - 10-14-2017, 04:59 PM
RE: I need some help with this repair - by Pete O - 10-16-2017, 04:01 AM



Users browsing this thread: 1 Guest(s)