DRO fitting
#5
(11-18-2017, 04:33 AM)toglhot Wrote: Don't know how I ever got along without a DRO. 

Typically in industry a DRO costing $1500 to $2000 will pay for itself in a month or less just from increased efficiency without even considering improved quality.  I was cutting some 1.750" X 3 TPI acme threads and turned the cross slide in one turn too far.  Needless to say that caused pieces to go flying and I needed to change my underwear.   Smiley-signs081

A DRO would have paid for itself with that single Smiley-signs139

Almost forgot.  Very good job on the installation.
Reply
Thanks given by:


Messages In This Thread
DRO fitting - by toglhot - 11-18-2017, 04:33 AM
RE: DRO fitting - by pepi - 11-18-2017, 07:38 AM
RE: DRO fitting - by Ed ke6bnl - 11-18-2017, 09:36 AM
RE: DRO fitting - by Highpower - 11-18-2017, 12:53 PM
RE: DRO fitting - by Dr Stan - 11-18-2017, 02:13 PM
RE: DRO fitting - by Vinny - 11-21-2017, 06:43 PM



Users browsing this thread: 1 Guest(s)