01-14-2018, 11:04 AM
I'd probably slot horizontal on one face and vertical on the other between the webs. I'd put a vertical slot between the web and the edges if there is sufficient room.
Hunting American dentists since 2015.
|
Fabricated angle plate
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Fabricated angle plate - by SteveG - 01-14-2018, 01:35 AM
RE: Fabricated angle plate - by SteveG - 01-14-2018, 01:38 AM
RE: Fabricated angle plate - by f350ca - 01-14-2018, 10:32 AM
RE: Fabricated angle plate - by Mayhem - 01-14-2018, 11:04 AM
RE: Fabricated angle plate - by pepi - 01-14-2018, 06:50 PM
RE: Fabricated angle plate - by SteveG - 01-15-2018, 02:39 AM
RE: Fabricated angle plate - by f350ca - 01-15-2018, 10:00 AM
RE: Fabricated angle plate - by Dr Stan - 01-15-2018, 01:00 PM
RE: Fabricated angle plate - by SteveG - 01-15-2018, 04:59 PM
RE: Fabricated angle plate - by Dr Stan - 01-16-2018, 11:50 AM
|
Users browsing this thread: 1 Guest(s)