|
Help Tight offset bend
|
02-05-2018, 10:36 PM
I've no experience, but off the top of my head something like a flat bar bender with a groove machined in the die and also on the moving die should allow you to go quite tight without flattening the round profile of the stock. I'd think with a couple of suitable stops it would be pretty repeatable.
Steve Thanks given by: Mike s.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tight offset bend - by Mike s. - 02-05-2018, 08:42 PM
RE: Tight offset bend - by SteveG - 02-05-2018, 10:36 PM
RE: Tight offset bend - by Hawkeye - 02-05-2018, 11:35 PM
RE: Tight offset bend - by Mike s. - 02-06-2018, 06:57 PM
RE: Tight offset bend - by Vinny - 02-06-2018, 09:04 PM
RE: Tight offset bend - by randyc - 02-08-2018, 10:03 PM
RE: Tight offset bend - by Dr Stan - 02-06-2018, 07:32 PM
RE: Tight offset bend - by Hawkeye - 02-06-2018, 11:31 PM
RE: Tight offset bend - by TomG - 02-09-2018, 07:19 AM
|
