Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe
#5
Dave,

That will come in real handy. Smiley-signs107

I have to say I am always a little wary of 'press' fitting into cast iron. I think heating one component and cooling (freezing) the other is a much better way to do it. Thumbsup

Nicely posted and well photographed.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by DaveH - 05-09-2012, 07:36 AM



Users browsing this thread: 2 Guest(s)