Help DRO Questions
#8
Trevor, it took me several tries to get mine figured out. It seemed to work just the opposite of the way I expected it to. It turns out I had my scales set to read in the wrong direction at first.   Slaphead

Once I corrected that my next hurtle was figuring out where the correct starting point was. I assumed it would be the 12:00 position as a default. Again I was wrong, as the default on my DRO is at the 3:00 position.   Slaphead

Yours may be different. My point being... try doing a few dry runs with a piece of paper on the table and a Sharpie in the drill chuck. Just bring the quill down to 'spot' your pattern on paper to check to see if it comes out right. When it does all of a sudden you will 'get it' and it will be dead simple to do after that. At least that's how it happened for me.   Big Grin

   
Willie
Reply
Thanks given by:


Messages In This Thread
DRO Questions - by Cross Slide - 03-25-2018, 05:35 PM
RE: DRO Questions - by TomG - 03-25-2018, 07:24 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 08:42 PM
RE: DRO Questions - by TomG - 03-25-2018, 09:02 PM
RE: DRO Questions - by Highpower - 03-25-2018, 08:57 PM
RE: DRO Questions - by kwoodhands - 03-26-2018, 05:54 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 09:01 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 09:49 PM
RE: DRO Questions - by Highpower - 03-26-2018, 09:46 AM
RE: DRO Questions - by Cross Slide - 03-26-2018, 06:56 PM
RE: DRO Questions - by Highpower - 03-26-2018, 09:40 PM
RE: DRO Questions - by Cross Slide - 03-26-2018, 11:13 PM
RE: DRO Questions - by Highpower - 03-27-2018, 12:02 PM
RE: DRO Questions - by EdK - 03-27-2018, 04:19 PM
RE: DRO Questions - by Robert - 03-29-2018, 06:47 PM
RE: DRO Questions - by Vinny - 03-29-2018, 09:25 PM
RE: DRO Questions - by Cross Slide - 03-30-2018, 06:28 PM
RE: DRO Questions - by terrywerm - 04-01-2018, 07:24 AM



Users browsing this thread: 1 Guest(s)