MetalworkingFun Forum › Machining › General Metalworking Discussion v
Advice on bending 1/4" flat bar steel

Thread Modes
Advice on bending 1/4" flat bar steel
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
Brett6366 (04-10-2018)
#2
04-10-2018, 11:26 AM
The industry standard for something like that would be a hydraulic press brake, but you couldn't touch one even used for that kind of money. Better find out if there are stops that can be set for production runs like you are planning.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
RE: Advice on bending 1/4" flat bar steel - by TomG - 04-10-2018, 11:26 AM



Users browsing this thread: 1 Guest(s)