Lifting chucks and vises.
#4
Hi Dave,

My plan is to bolt a swing arm to the wall so I can lift my vise and rotary table from a shelf to the mill table without lifting them. I need to clean and rearrange the shop before that happens though. Blink

Ed
Reply
Thanks given by:


Messages In This Thread
Lifting chucks and vises. - by Dave J - 05-10-2012, 03:07 AM
RE: Lifting chucks and vises. - by EdK - 05-10-2012, 06:19 AM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 06:54 AM
RE: Lifting chucks and vises. - by EdK - 05-10-2012, 06:59 AM
RE: Lifting chucks and vises. - by Mayhem - 05-10-2012, 07:03 AM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 07:59 AM
RE: Lifting chucks and vises. - by Mayhem - 05-10-2012, 08:14 AM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 09:21 AM
RE: Lifting chucks and vises. - by f350ca - 05-10-2012, 10:03 AM
RE: Lifting chucks and vises. - by Highpower - 05-10-2012, 03:28 PM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 10:55 AM
RE: Lifting chucks and vises. - by doubleboost - 05-10-2012, 01:40 PM
RE: Lifting chucks and vises. - by DaveH - 05-10-2012, 02:10 PM
RE: Lifting chucks and vises. - by DaveH - 05-10-2012, 02:12 PM



Users browsing this thread: 1 Guest(s)