Lifting chucks and vises.
#10
Nice cranes, I hope to have mine in soon but it has to span 25ft wide x 25ft long. I have 3/4 of the steel so far.

With the chucks I just turn the lathe spindle around if it needs it.
I did think of being able to rotate them, but if I wanted it to be able to turn them would have meant coming out further, which would mean I would have to make bigger storage boxes and I am short on space in my shop.
http://www.metalworkingfun.com/showthread.php?tid=29

Dave
Reply
Thanks given by:


Messages In This Thread
Lifting chucks and vises. - by Dave J - 05-10-2012, 03:07 AM
RE: Lifting chucks and vises. - by EdK - 05-10-2012, 06:19 AM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 06:54 AM
RE: Lifting chucks and vises. - by EdK - 05-10-2012, 06:59 AM
RE: Lifting chucks and vises. - by Mayhem - 05-10-2012, 07:03 AM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 07:59 AM
RE: Lifting chucks and vises. - by Mayhem - 05-10-2012, 08:14 AM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 09:21 AM
RE: Lifting chucks and vises. - by f350ca - 05-10-2012, 10:03 AM
RE: Lifting chucks and vises. - by Highpower - 05-10-2012, 03:28 PM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 10:55 AM
RE: Lifting chucks and vises. - by doubleboost - 05-10-2012, 01:40 PM
RE: Lifting chucks and vises. - by DaveH - 05-10-2012, 02:10 PM
RE: Lifting chucks and vises. - by DaveH - 05-10-2012, 02:12 PM



Users browsing this thread: 1 Guest(s)