PMC parameters
#1
I have a SMG model V32 vertical cnc mill and lost the PMC parameters. Can anyone help direct me to the files ?
 Thanks for your help.
Reply
Thanks given by:
#2
Would those perhaps actually be the PLC parameters?


(Programmable Logic Controller)
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
#3
No, PMC is Programmable Machine Controller.

ICETP, What's the make and model of the PMC? Is it a Fanuc?
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by: ICETP
#4
the model is V-32, has a O-M fanuc.
Reply
Thanks given by:
#5
CNC Zone has some guys that know the Fanuc OM - https://www.cnczone.com. Check the forums.

I also found a couple of youtube videos where someone paged thru all the params and diags in case they lost their configs.  

The Fanuc OM manual gives the meanings of the parameters:  Fanuc Handbook I don't know if that'll help at all.

I haven't done anything with anything Fanuc in over 25 years, so that's about the limit of what I can do for you. Perhaps we have some other Fanuc guys here that can help.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by: ICETP
#6
I can do Fanuc 6M but not  OM :(
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)