MetalworkingFun Forum › Machining › Projects v
Disc sander build

Thread Modes
Disc sander build
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan
#3
09-29-2018, 11:22 AM
Looks like a fun project, Pete. You really lucked out with that leak in your flask. Happyyes

I just went out and measured the gap on my Delta disk sander and it was about 3/32".

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: Pete O


Messages In This Thread
Disc sander build - by Pete O - 09-29-2018, 08:04 AM
RE: Disc sander build - by Pete O - 09-29-2018, 08:34 AM
RE: Disc sander build - by TomG - 09-29-2018, 11:22 AM
RE: Disc sander build - by Pete O - 09-29-2018, 05:58 PM
RE: Disc sander build - by the penguin - 09-30-2018, 12:02 PM
RE: Disc sander build - by Pete O - 09-30-2018, 06:50 PM
RE: Disc sander build - by Dr Stan - 09-30-2018, 08:36 PM
RE: Disc sander build - by Pete O - 10-01-2018, 04:26 AM
RE: Disc sander build - by Pete O - 10-03-2018, 01:02 AM
RE: Disc sander build - by Vinny - 10-03-2018, 08:27 AM
RE: Disc sander build - by Pete O - 10-04-2018, 02:34 AM
RE: Disc sander build - by Vinny - 10-04-2018, 04:26 PM
RE: Disc sander build - by Pete O - 10-05-2018, 01:40 AM
RE: Disc sander build - by Pete O - 10-06-2018, 05:01 AM
RE: Disc sander build - by f350ca - 10-06-2018, 08:41 AM
RE: Disc sander build - by TomG - 10-06-2018, 08:42 AM
RE: Disc sander build - by Pete O - 10-06-2018, 06:10 PM
RE: Disc sander build - by Pete O - 10-13-2018, 09:58 PM



Users browsing this thread: 1 Guest(s)