1st part I've made.
#2
(11-08-2018, 06:53 PM)Swarf_Newbie Wrote: Here be the first part I have made on a lathe since the very early 80's!

Its a 1/2" unf silencer adaptor for a CO2 rifle I use for ratting.

And its also my first proper attempt at anodising!

No laughing!



Also my 1st attempt at screw cutting a barrel......not so good, but practice makes perfect(so they say!)



Cheers.

Roy.

G'day Roy,

Some might say its been a long time between drinks :)  Here's a picture of the first part with left hand thread I made on my Lantaine Lathe September 2017 (the 1" nut was bought from a Nuts & Bolts supplier):
   
Reply
Thanks given by:


Messages In This Thread
1st part I've made. - by Swarf_Newbie - 11-08-2018, 06:53 PM
RE: 1st part I've made. - by castellated nut - 01-23-2019, 08:17 PM



Users browsing this thread: 1 Guest(s)