Drilling 95% Tungsten Darts
#5
(12-15-2018, 11:07 AM)TomG Wrote: Tungsten is hard and not very ductile so it can be a challenge to machine. It requires sharp carbide tooling with lots of clearance and relief, That fact and the high temperatures generated causes the tooling to wear very quickly, so keep and eye on it. Cutting speeds are similar to grey iron but with slower feed rates. If you try to push it, it pushes back big time. Rigid setups are also necessary due to the high machining forces and any chatter will chip the tool.

It's been a while since I've machined tungsten, but I definitely don't miss it. Bleh

Tom

Thank you, Tom.  I've not done grey iron before.  Given that I'll be using a 3mm drill, what's the recommended speed?

I'll visit the hardware shop near my office tomorrow to see if I can pick up a couple of carbide drill.

Regards,
Wongster
Wongster
http://www.wongstersproduction.com

Proud to be a member of MetalworkingFun Forum since Mar 2012.
Reply
Thanks given by:


Messages In This Thread
Drilling 95% Tungsten Darts - by Wongster - 12-15-2018, 02:24 AM
RE: Drilling 95% Tungsten Darts - by TomG - 12-15-2018, 11:07 AM
RE: Drilling 95% Tungsten Darts - by Wongster - 12-16-2018, 08:46 AM
RE: Drilling 95% Tungsten Darts - by TomG - 12-16-2018, 09:44 AM
RE: Drilling 95% Tungsten Darts - by awemawson - 12-15-2018, 01:17 PM
RE: Drilling 95% Tungsten Darts - by Mike E. - 12-16-2018, 06:07 AM
RE: Drilling 95% Tungsten Darts - by Wongster - 12-16-2018, 08:49 AM
RE: Drilling 95% Tungsten Darts - by Mike E. - 12-16-2018, 09:24 AM
RE: Drilling 95% Tungsten Darts - by Wongster - 12-23-2018, 08:36 PM
RE: Drilling 95% Tungsten Darts - by Umahunter - 12-27-2018, 05:01 AM
RE: Drilling 95% Tungsten Darts - by Roadracer_Al - 12-31-2018, 01:40 PM



Users browsing this thread: 2 Guest(s)