Lathe LED light
#4
Thanks Ed,
I just sprayed it with some cheap $2 spray can strait over the metal, no tumbling, not even undercoat.

I did have some pictures of it in pieces before welding, but not sure where they have gone or which card there on, but if I find them I will post them up.

Dave
Reply
Thanks given by:


Messages In This Thread
Lathe LED light - by Dave J - 05-11-2012, 09:57 AM
RE: Lathe LED light - by Dave J - 05-11-2012, 10:03 AM
RE: Lathe LED light - by EdK - 05-11-2012, 10:07 AM
RE: Lathe LED light - by Dave J - 05-11-2012, 10:11 AM
RE: Lathe LED light - by EdK - 05-11-2012, 10:14 AM
RE: Lathe LED light - by dallen - 05-11-2012, 09:55 PM
RE: Lathe LED light - by EdK - 05-12-2012, 08:14 AM
RE: Lathe LED light - by Dave J - 05-11-2012, 10:31 AM
RE: Lathe LED light - by ETC57 - 05-11-2012, 10:58 AM
RE: Lathe LED light - by Dave J - 05-11-2012, 11:05 AM
RE: Lathe LED light - by f350ca - 05-11-2012, 12:28 PM
RE: Lathe LED light - by doubleboost - 05-11-2012, 01:56 PM
RE: Lathe LED light - by DaveH - 05-11-2012, 02:12 PM



Users browsing this thread: 1 Guest(s)