MetalworkingFun Forum › Machining › Gunsmithing v
CZ455

Thread Modes
CZ455
Roadracer_Al Offline
Junior
****
Posts: 691
Threads: 14
Joined: Feb 2015
Location: Oakland, California
#13
02-21-2019, 12:53 AM
The sight I chose was highly recommended on RimfireCentral. It's a Mueller 8x32x44 with a target reticle and 1/2 MOA adjustments.

I also procured an inch/lb reading 1/4" drive torque wrench, which was previously missing from my wrench drawer.

I'll get it mounted and shoot next week and see how things go.
Reply
Thanks given by:


Messages In This Thread
CZ455 - by Roadracer_Al - 12-30-2018, 04:07 PM
RE: CZ455 - by 12345678910 - 01-17-2019, 06:02 AM
RE: CZ455 - by Roadracer_Al - 01-23-2019, 03:37 AM
RE: CZ455 - by TomG - 01-23-2019, 09:21 PM
RE: CZ455 - by Highpower - 01-24-2019, 12:50 AM
RE: CZ455 - by TomG - 01-24-2019, 10:11 AM
RE: CZ455 - by Highpower - 01-24-2019, 09:02 PM
RE: CZ455 - by Roadracer_Al - 01-27-2019, 11:25 PM
RE: CZ455 - by Highpower - 01-28-2019, 11:13 PM
RE: CZ455 - by Roadracer_Al - 02-05-2019, 06:56 PM
RE: CZ455 - by Roadracer_Al - 02-07-2019, 01:59 AM
RE: CZ455 - by TomG - 02-07-2019, 08:54 AM
RE: CZ455 - by Roadracer_Al - 02-21-2019, 12:53 AM



Users browsing this thread: 1 Guest(s)