MetalworkingFun Forum › Machining › Projects v
Bending Iron

Thread Modes
Bending Iron
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 3 users Like TomG's post:
EdK (03-10-2019), JScott (03-11-2019), Highpower (03-11-2019)
#12
03-10-2019, 07:34 PM
Finished the thing up today and ran it up to 450ºF with no trouble. Since the chassis is all metal, I tossed the two conductor cord and opted for one with a ground. I was playing around with some of the settings on the PID and it's amazing how well it works for a $20 controller. Once stabilized, it held the set temp within a degree.

Tom

[Image: 20190310_202003.jpg]

[Image: 20190310_201447.jpg]
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Bending Iron - by TomG - 03-08-2019, 05:31 PM
RE: Bending Iron - by awemawson - 03-08-2019, 05:45 PM
RE: Bending Iron - by Vinny - 03-08-2019, 07:19 PM
RE: Bending Iron - by Pete O - 03-08-2019, 09:17 PM
RE: Bending Iron - by Clifford B. - 03-08-2019, 10:11 PM
RE: Bending Iron - by TomG - 03-08-2019, 11:42 PM
RE: Bending Iron - by awemawson - 03-09-2019, 02:44 AM
RE: Bending Iron - by TomG - 03-09-2019, 08:08 AM
RE: Bending Iron - by Highpower - 03-09-2019, 10:31 AM
RE: Bending Iron - by Vinny - 03-09-2019, 04:07 PM
RE: Bending Iron - by TomG - 03-09-2019, 04:44 PM
RE: Bending Iron - by TomG - 03-10-2019, 07:34 PM
RE: Bending Iron - by Vinny - 03-11-2019, 12:14 PM
RE: Bending Iron - by TomG - 03-11-2019, 03:56 PM
RE: Bending Iron - by Dr Stan - 03-11-2019, 06:51 PM
RE: Bending Iron - by TomG - 03-11-2019, 11:31 PM



Users browsing this thread: 1 Guest(s)