MetalworkingFun Forum › Machining › Projects v
Huff & Puff

Thread Modes
Huff & Puff
Doc55 Offline
Freshman
**
Posts: 33
Threads: 11
Joined: Jan 2016
Location: ND
The following 6 users Like Doc55's post:
Davyboy (04-06-2019), f350ca (04-06-2019), Vinny (04-06-2019), TomG (04-06-2019), EdK (04-06-2019), JScott (04-08-2019)
#9
04-06-2019, 06:05 PM
Well got a little done today between going and getting my pepper seeds and tomato seeds and starting soil. Tomorrow I plan on getting them planted in the starting tray.

  So anyway I did get the crank done
also the slide valve and piston.
Reply
Thanks given by:


Messages In This Thread
Huff & Puff - by Doc55 - 04-03-2019, 09:38 AM
RE: Huff & Puff - by TomG - 04-03-2019, 01:08 PM
RE: Huff & Puff - by awemawson - 04-03-2019, 03:35 PM
RE: Huff & Puff - by TomG - 04-03-2019, 04:06 PM
RE: Huff & Puff - by Doc55 - 04-03-2019, 06:27 PM
RE: Huff & Puff - by Doc55 - 04-04-2019, 05:00 PM
RE: Huff & Puff - by TomG - 04-04-2019, 07:44 PM
RE: Huff & Puff - by Doc55 - 04-05-2019, 03:59 PM
RE: Huff & Puff - by Doc55 - 04-06-2019, 06:05 PM
RE: Huff & Puff - by Doc55 - 04-10-2019, 09:32 PM
RE: Huff & Puff - by Doc55 - 04-11-2019, 11:23 PM



Users browsing this thread: 1 Guest(s)