drill project
#4
right the last bit after letting them cool dawn i pleased them in the acid with the other two to remove the flux residue then after sum time i got them out of the acid and gave them a good scrubbing with running water to remove all the acid then back on to the wire brush then i gave the one that was rusty a coting of rust inhibitor and the others a coting of light machine oil right last pics


Attached Files Thumbnail(s)
                   
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
drill project - by krv3000 - 05-13-2012, 01:35 PM
RE: drill project - by krv3000 - 05-13-2012, 01:52 PM
RE: drill project - by doubleboost - 05-13-2012, 02:03 PM
RE: drill project - by krv3000 - 05-13-2012, 02:31 PM
RE: drill project - by doubleboost - 05-13-2012, 02:37 PM
RE: drill project - by aametalmaster - 05-13-2012, 02:41 PM
RE: drill project - by krv3000 - 05-13-2012, 04:39 PM
RE: drill project - by krv3000 - 05-13-2012, 04:05 PM
RE: drill project - by doubleboost - 05-13-2012, 04:11 PM
RE: drill project - by krv3000 - 05-13-2012, 05:11 PM
RE: drill project - by Rickabilly - 06-11-2012, 08:36 AM
RE: drill project - by doubleboost - 05-13-2012, 05:17 PM
RE: drill project - by krv3000 - 05-13-2012, 05:32 PM
RE: drill project - by krv3000 - 05-13-2012, 05:39 PM
RE: drill project - by Highpower - 05-13-2012, 09:15 PM
RE: drill project - by DaveH - 05-14-2012, 05:49 AM
RE: drill project - by Mayhem - 05-14-2012, 06:07 AM
RE: drill project - by stevec - 05-14-2012, 07:43 AM
RE: drill project - by EdK - 05-14-2012, 08:19 AM
RE: drill project - by ETC57 - 05-14-2012, 01:58 PM
RE: drill project - by Mayhem - 05-14-2012, 08:27 AM
RE: drill project - by krv3000 - 05-15-2012, 01:58 AM
RE: drill project - by krv3000 - 06-05-2012, 06:06 PM
RE: drill project - by stevec - 06-11-2012, 03:24 PM



Users browsing this thread: 1 Guest(s)