Drill Press Stops
#4
Good points, guys. I should have mentioned clamping the vise down, but I was only showing those vise stops as a background for the table stops. I did mention that they weren't clamps, so back shims could be considered optional. If you have a heavy hand on the quill, I'd say they should be mandatory.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Drill Press Stops - by Hawkeye - 06-05-2019, 09:35 AM
RE: Drill Press Stops - by Dr Stan - 06-05-2019, 02:47 PM
RE: Drill Press Stops - by Highpower - 06-05-2019, 03:34 PM
RE: Drill Press Stops - by Hawkeye - 06-05-2019, 08:17 PM
RE: Drill Press Stops - by pepi - 06-17-2019, 10:19 AM
RE: Drill Press Stops - by Hawkeye - 06-17-2019, 10:19 PM
RE: Drill Press Stops - by pepi - 06-18-2019, 08:49 PM
RE: Drill Press Stops - by Dr Stan - 06-19-2019, 11:34 AM



Users browsing this thread: 1 Guest(s)