|
Brainstorming
|
|
07-16-2019, 09:19 AM
You'll get the best surface finish on light machinery, like most of us have at home, with a properly ground high speed tool bit. Carbide is capable of better finishes, but only when used on heavy machinery with more power and much better rigidity.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) Thanks given by: pepi
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Brainstorming - by pepi - 07-14-2019, 08:03 AM
RE: Brainstorming - by Highpower - 07-14-2019, 11:11 AM
RE: Brainstorming - by awemawson - 07-14-2019, 12:20 PM
RE: Brainstorming - by TomG - 07-14-2019, 09:07 PM
RE: Brainstorming - by Dr Stan - 07-15-2019, 07:03 AM
RE: Brainstorming - by pepi - 07-16-2019, 07:13 AM
RE: Brainstorming - by TomG - 07-16-2019, 09:19 AM
RE: Brainstorming - by Highpower - 07-17-2019, 08:50 AM
RE: Brainstorming - by pepi - 07-17-2019, 11:01 PM
RE: Brainstorming - by Dr Stan - 07-18-2019, 12:56 PM
RE: Brainstorming - by Doc55 - 07-20-2019, 09:53 AM
RE: Brainstorming - by pepi - 07-25-2019, 08:25 AM
RE: Brainstorming - by Dr Stan - 08-25-2019, 04:27 PM
|
