MetalworkingFun Forum › Machinery › Milling Machines v
Purpose??

Thread Modes
Purpose??
EdK Offline
Whipping Boy
*******
Posts: 8,744
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
The following 1 user Likes EdK's post:
Highpower (10-13-2019)
#2
10-13-2019, 04:38 PM
(10-11-2019, 03:08 PM)Paulc Wrote: My new LMS high torque Mini mill has a t slot on the front edge of the table with a round hole at each end.

Regular tee nuts don't fit, so what is the purpose of this slot??

Those are usually used for manual stops. At least that's what I've used them for.

By the way, Welcome to the forum Paul.

Ed
Reply
Thanks given by:


Messages In This Thread
Purpose?? - by Paulc - 10-11-2019, 03:08 PM
RE: Purpose?? - by EdK - 10-13-2019, 04:38 PM
RE: Purpose?? - by Highpower - 10-13-2019, 07:16 PM
RE: Purpose?? - by Paulc - 10-13-2019, 08:10 PM
RE: Purpose?? - by Vinny - 10-13-2019, 09:54 PM
RE: Purpose?? - by Dr Stan - 10-17-2019, 12:09 PM
RE: Purpose?? - by Paulc - 10-17-2019, 03:07 PM
RE: Purpose?? - by d65 - 02-15-2020, 12:00 AM



Users browsing this thread: 1 Guest(s)