Mill a circle
#1
If one doesn't have a rotary table, how would you mill the  circumference of a circular piece with a small stem (think banjo shape)?
Reply
Thanks given by:
#2
Lots of facets... https://www.youtube.com/watch?v=hTj6LC6agrg

A mill with a digital readout that has an arc function will work too.
Willie
Reply
Thanks given by:
#3
Looks good. Have to give it a try.
Thanks for the tip.
Reply
Thanks given by:
#4
It could also be accomplished using a fixture with some stop pins assuming one could have a pin hole in the center of the circle. Just make sure you conventional mill, not climb mill.
Reply
Thanks given by:
#5
You are looking at this all wrong. You NEED a rotary table. Use this opportunity to buy yourself a new (or used) rotary table.

"Honey, I gotta have one. It's the only way to finish my project."
Full of ideas, but slow to produce parts
Reply
Thanks given by:
#6
(10-18-2019, 08:36 AM)rleete Wrote: You are looking at this all wrong.  You NEED a rotary table.  Use this opportunity to buy yourself a new (or used) rotary table.

"Honey, I gotta have one.  It's the only way to finish my project."

You're really making it hard to not get a rotary table.
Reply
Thanks given by:
#7
(10-18-2019, 03:11 PM)Paulc Wrote:
(10-18-2019, 08:36 AM)rleete Wrote: You are looking at this all wrong.  You NEED a rotary table.  Use this opportunity to buy yourself a new (or used) rotary table.

"Honey, I gotta have one.  It's the only way to finish my project."

You're really making it hard to not get a rotary table.

But rleete is correct.  How do you think I ended up with a 24 X 48 X 12ft shop packed full of tools? Big Grin Big Grin Big Grin Big Grin 

And yes I have a rotary table and an indexer.
Reply
Thanks given by:
#8
(10-18-2019, 03:11 PM)Paulc Wrote:
(10-18-2019, 08:36 AM)rleete Wrote: You are looking at this all wrong.  You NEED a rotary table.  Use this opportunity to buy yourself a new (or used) rotary table.

"Honey, I gotta have one.  It's the only way to finish my project."

You're really making it hard to not get a rotary table.

Keep in mind that a rotary table has more uses than just cutting circles and arcs. They are also useful for indexing/dividing as well.

[Image: attachment.php?aid=12457]

[Image: attachment.php?aid=12553]
Willie
Reply
Thanks given by:
#9
Just added a HT furnace to my "need" list. Big Grin
Reply
Thanks given by:
#10
You guys are quite persuasive Big Grin .
Finally broke down and ordered a rotary table.

Now just have to figure out how to use it!  Blush
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)