Mill a circle
#12
(10-19-2019, 03:25 PM)Dr Stan Wrote: Just added a HT furnace to my "need" list. Big Grin

Rotfl

By the way Stan, what goes around comes around. Watching Joe's videos cost me dearly in the last couple of weeks. I now own not one, but two vintage magnetic dial indicator holders (US General and a Craftsman) because of that guy. I also got one of his rotary table alignment pins in the mail today. Big Grin
Willie
Reply
Thanks given by:


Messages In This Thread
Mill a circle - by Paulc - 10-17-2019, 03:11 PM
RE: Mill a circle - by Highpower - 10-17-2019, 08:06 PM
RE: Mill a circle - by Paulc - 10-17-2019, 08:18 PM
RE: Mill a circle - by Dr Stan - 10-17-2019, 08:57 PM
RE: Mill a circle - by rleete - 10-18-2019, 08:36 AM
RE: Mill a circle - by Paulc - 10-18-2019, 03:11 PM
RE: Mill a circle - by Dr Stan - 10-18-2019, 07:31 PM
RE: Mill a circle - by Highpower - 10-19-2019, 10:48 AM
RE: Mill a circle - by Dr Stan - 10-19-2019, 03:25 PM
RE: Mill a circle - by Highpower - 10-19-2019, 08:00 PM
RE: Mill a circle - by Paulc - 10-19-2019, 03:39 PM
RE: Mill a circle - by Dr Stan - 10-19-2019, 04:36 PM



Users browsing this thread: 2 Guest(s)