My week this week! My workshop videos!
I work on the air filter and pre cleaner, fix the dodgy handbrake, which has been a pain since I bought this tractor , and work towards the three point linkage removal, remove the tow hitch and link arms, and start to free them all off using the dreaded Blowlamp of death, alternately known as the Flamefast Brazing hearth! In part 6 (out now!) We continue with the air cleaner get the hydralic/transmission drained and the filter out, what a mess!!

Phil, Some rain, some shine, in the East York Shire!



Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:
Parts 7&8
Fordson Major rebuild, the hydraulics and rear transmission case. I removed the top cover, and realised there was 3" depth of black sludge in the bottom of the transmission case, and this had remained after 30 litres of "oil" was drained off! I set on cleaning it with kerosene, and by the end of day one I was beginning to see the castings, and the unmarked gears etc. Thankfully there seems to be no grit or metal in the sludge, as the fordson does have a good filter, and two magnetic plugs before the pump! We have a wander in the field, and get the 2cv tractor up there.....eventually!
Phil, thunderstorms and a wet start to the Harvest, in the East York Shire!


Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:
Work on the Fordson Major E1A continues. I bite the bullet and remove the PTO gearbox, and it is a good thing, because both it and the gearbox were full of black sludge, everything gets a good powerwashing out and we use the weldanuton technique to get a sheared bolt out! I put on overalls, and elbow length gloves!, it was hot, but it kept me more or less clean! Part 10 out now at https://www.youtube.com/user/philhermetic/videos
Phil, Some rain, some shine, in the East York Shire!


Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:
Fordson Major rebuild, parts 11 and 12
Rebuilding the hydraulic pump for the Fordson Major E1A. Not hard, but cleanliness and an O ring kit are essential, and patience, quite a bit of patience! Hydralic pump and most ancilliaries get refitted, and I add a hot gunk parts washer to my wish list! Part 12 available now at https://www.youtube.com/user/philhermetic/videos Phil,
August is the new September in the East York Shire!


Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:
Fordson Major Rebuild part 13, we clean out the top cover, refit the piston, cylinder and valve block, and refit it to the tractor, along with the PTO gearbox and the PTO shaft, and quite suddenly, it is a who;e tractor again.....more or less!! Part 14, out now at https://www.youtube.com/user/philhermetic/videos
Phil, Dull all week, but a warm and sunny Saturday in East Yorkshire


Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:
Fordson Major Steering box strip and rebuild. Parts 15&16. 1955 E1A Fordson Diesel Major. In Part 16, out now, I finsh the steering box and refit it to the tractor, and get some paint on! Part 16 out now at https://www.youtube.com/user/philhermetic/videos
Phil, in definitely autumnal East Yorkshire


Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:
Fordson E1A major rebuild Part 17 strip and rebuild of the front steering and kingpins (steering swivels) It is not pretty, but all is repairable! luckily the parts I do need are all available, and not expensive, which is amazing for a 1955 tractor!! Part 18, out now at https://www.youtube.com/user/philhermetic/videos
Phil, In humid and hot East Yorkshire!!


Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:
Fordson E1A major, Only one video this week chaps, because we did a "poo" run on Moday afternoon, and the workshop power was off on Wednesday! I get the wheels finished in two coats of primer each, and then onto the kingpins/steering swivels. I put the extra grease slot on the RHS and then start the LHS, but find when I get the nuts off the bolts, the bolts are seized in the axle, It all makes life interesting, and I get it all in bits by Friday, and show the process of fitting the kingpins to the new bushes if you don't have the factory reamer available! (Video scheduled for release at 4pm GMT)
Phil, Warm and wet in East Yorkshire


Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:
Fordson Major rebuild, finishing off the steering swivels/king pins, and the track rod and drag link, and Richard turns up with my kitchen unit so I spend a couple of days fitting kitchens and plumbing! YUK. but I plough on and get it more or less finished. It will really make a difference to be able to wash the cups and fill the kettle in the same room where I make tea!
It's still warm and sunny in East Yorkshire!
Phil


Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:
Fordson E1A major, rebuilding the drag link, refitting the wheel;s, rebuilding the horn, and paint on Friday so it has the weekend fror drying. I also get the tea room sink plumbed in, and the worktop fixed down!
Phil, in wet and windy East Yorkshire.


Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)